Page 1 of 1
Trim too sensitive
Posted:
Sun Oct 24, 2004 12:14 amby Selbio
Hi all,
How do I change the trim sensitivity? I just have to press the trim up or down button once and the aircraft behaves unrealisticly.
Thanks in advance.
Re: Trim too sensitive
Posted:
Sun Oct 24, 2004 6:24 amby papa-metro
Open the aircraft.cfg file with notepad or similar and look for rudder trim effectiveness and elevator trim effectiveness. there is a figure following there, usually about 1.0 type in a lesser number ie .75 and save the change. This willl reduce the up/down or sideways movement when you adjust the trim from within the A/C. You will have to repeat this for each plane that is too sensitive, of course.
papa-metro usaf 1953-57
Re: Trim too sensitive
Posted:
Sun Oct 24, 2004 6:53 amby philsymonds
I've set ALL my aircraft to a setting of 0.4-0.6
I find this a very good setting
Re: Trim too sensitive
Posted:
Sun Oct 24, 2004 9:06 amby Selbio
Thanks a lot to both of you. I will try that right this second
Re: Trim too sensitive
Posted:
Sat Oct 30, 2004 1:08 amby wilderobb
Most Excellent advice! I was browzing through and read your question and the answers. I was about to junk a plane because I had the same problem. It saved my plane!! (Gulfstream G-100)
Re: Trim too sensitive
Posted:
Sat Oct 30, 2004 7:51 amby dave3cu
If using joystick to control, to reduce the sensitivity globally, go to Settings/Controls/Assignments, locate the 'elevator trim-up/down' assignments and reduce the 'repeat' slider.
Cheers,
Dave