If you want to land the opposite way on a runway to the ILS beam direction for some reason, wind direction maybe... you can track the ILS localiser from the opposite end. (back end). It is a bit awkward as you have to use the opposite movements on the stick to follow the localiser ie..fly left when you would normally fly right to keep on track. I guess the BC button on the AP lets you lock onto this backcourse under autopilot Unfortunately there is no glide slope to follow so that makes it even more tricky especially in poor visibilty
Have a go....you can ONLY kill yourself and all the paying passengers
"In theory, there is no difference between theory and practice. But, in practice, there is."
That is funny.... I was going to answer the last nine holes at a golf course. It wouldn't be much different, my swing usually changes from left to right on the back course.
Windows XP SP1 Motherboard: Epox 8RDA + main board Processor: AMD XP2500 Barton CPU Memory: PC2700 1gb Geil DDR Hard Drive: SEA HDD IDE 40GB 7M 40GPP Hard Drive: Western Digital 40gb 8mb cache Monitor 15 LCD Flat Panel Displa
Say you're landing on the 'back course' of runway 27, 270 degrees - therefore, landing on Runway 9, 90 degrees - what you DON't do is set the course on the VOR to 90 degrees.
Last edited by Nav on Tue Oct 12, 2004 10:40 am, edited 1 time in total.
Lots of runways have ils frequencies at both ends but this bc mode allows you to approach from either direction on runways that don't... well that's how I use it and it works just fine.....so ..yes I guess you have it there allrot. Set up an ILS approach as normal, then fly round to the other end and put the ap in bc (or rev I think it is in the cessna), and watch the needle and runway line up. just control your descent.
"In theory, there is no difference between theory and practice. But, in practice, there is."