Simviation Forums

Hi
Recently i installed an exellent (I suppose) panel for a B737-800 plane in a Kittyhawk 737-800 plane.
It seems that the installation was correct as my plane
shown this new panel but .......!
The switches works only once!
If I try to used it ( to start the engins) nothing move any more.I am obliged to restart my FS to get thinks
moving but again only for one time.
Anybody have similar problems?
I could not found this topic in the forum.
For any gidance I would be very thankfull.
slammer - france

Hi

The HMolina panels I have have a hidden upper panel that you need to use to get the engines going. If your panel has this hidden secondary panel open it and make sure the APU is running and the fuel  taps are turned on for the engines. There's probably something I'm forgetting to mention but if you fool around with it enough you should get it going. Other than the above I can't imagen what the problem is.

cheers/ Nek

thanks a lot , you save my day!
slammer