Simviation Forums

I recently downloaded the Bonanza Twin, I also downloaded a different panel for it. The problem with the new panel is when I use my hatswitch to look out either side, and then release it to go back to the forward view, the wings from the side view will now be in the forward view
Anyone ever had this problem with an airplane, or know how to correct this problem?
Thanx

So you are flying with your wing in front  :o ?

Had the same problem with the same aircraft. If I remember I re-installed which stopped the problem with the 'views' but now when I select the aircraft from 'create a flight' and go to 'fly' I get a 'compressed' looking panel, similar to a 'landing' view. I then have to re-slect the aircraft from the drop down menu and all is well. I also found in some aircraft that the hat switch (I am using a yoke) gives problems with the views (freezing) so I tend to use the keyboard number pad keys a lot.    

I hadnt thought about using the number pad, I will try that and see what happens  ;D
Thanx

Tried the number pad and it still does the same thing.........

I'm no expert but my own experience is when I get problems with third party downloads I always check any readme notes again just to check I've done what I should have when installing and if in any doubt try a re-install.  If that fails I usually try a different author. If you are not having problems with any other aircraft in your hangar it's likely but not certain, it may not have installed correctly.