Honeycomb A & B on FS9
Posted: Tue Oct 07, 2025 12:48 amHey guys & gals!
Is anyone using the Honeycomb Alpha & Bravo successfully in FS9?
I'm setting up my flight sim gear after a few years off, on a store-bought cockpit (finally!
). I'm having trouble setting up my Bravo throttle quadrant though. The Throttle and Prop just bob back and forth near the fully open position when I try to drag them with the cursor or use the Throttle or Prop quadrant controls. The Mixture was working in reverse for a few minutes before I tinkered with something, and now I can only drag it with the cursor, but there is no response at all from the Mixture quadrant control.
I've used the Main Menu/Settings with partial/inconsistent success with the Mixture knob, but mostly failure.
I've also used the paid version of FSUIPC 3.999 with no success at all as far as throttle quadrant set up.
The equipment is working as far as calibrations and button bindings - I even got the 'dreaded' Bravo elevator trim issue straightened out! So, I have reason to be hopeful. I also have the equipment set up in MSFS 2020 successfully. I'm working through some similar issues in P3D v4.5, but I haven't put much effort into P3D yet.
Any insights, thoughts or ideas welcomed. Thanks!
Is anyone using the Honeycomb Alpha & Bravo successfully in FS9?
I'm setting up my flight sim gear after a few years off, on a store-bought cockpit (finally!
). I'm having trouble setting up my Bravo throttle quadrant though. The Throttle and Prop just bob back and forth near the fully open position when I try to drag them with the cursor or use the Throttle or Prop quadrant controls. The Mixture was working in reverse for a few minutes before I tinkered with something, and now I can only drag it with the cursor, but there is no response at all from the Mixture quadrant control.I've used the Main Menu/Settings with partial/inconsistent success with the Mixture knob, but mostly failure.
I've also used the paid version of FSUIPC 3.999 with no success at all as far as throttle quadrant set up.
The equipment is working as far as calibrations and button bindings - I even got the 'dreaded' Bravo elevator trim issue straightened out! So, I have reason to be hopeful. I also have the equipment set up in MSFS 2020 successfully. I'm working through some similar issues in P3D v4.5, but I haven't put much effort into P3D yet.
Any insights, thoughts or ideas welcomed. Thanks!