Simviation Forums

Hi, all. First post here. After years of only knowing where a couple of my FS9 disks were, I've finally located all 4 and have loaded the program again. I'm pretty disappointed to find that Win7 does not have hardware drivers to support my MS Forcefeedback 2 joystick, but that's a different story. So, on to my question(s):

I've located a bunch of scenery for the Phoenix area, but I'm wondering if I've "left something on the table." One of the Hi-res files says it requires a low res file to work.

My question is, in what order do I put these in the add on scenery to get the best result?

To be more specific, what priority do I assign each of these, once loaded into the scenery?

FWIW, I'm using the FS2004 scenery by G. Razek. The file titled "FS2004/FSX Phoenix, Arizona Photo Scenery AddPack" specifies that it needs another file, which I already have.

Does this other "low-res" file get assigned a higher or lower value than the AZ Add Pack?

Just try the low res below the high res layer. If that doesn't work, switch them.

Thanks for the reply. I'll futz with it a bit. I spent last night trying to get ANY one of the f-16s to load. I don't remember it being this difficult when I had it all running in the past.