Need help with "ordering" of scenery... not payware related

[carlsoti]

Hi, all. First post here. After years of only knowing where a couple of my FS9 disks were, I've finally located all 4 and have loaded the program again. I'm pretty disappointed to find that Win7 does not have hardware drivers to support my MS Forcefeedback 2 joystick, but that's a different story. So, on to my question(s):

I've located a bunch of scenery for the Phoenix area, but I'm wondering if I've "left something on the table." One of the Hi-res files says it requires a low res file to work.

My question is, in what order do I put these in the add on scenery to get the best result?

To be more specific, what priority do I assign each of these, once loaded into the scenery?

FWIW, I'm using the FS2004 scenery by G. Razek. The file titled "FS2004/FSX Phoenix, Arizona Photo Scenery AddPack" specifies that it needs another file, which I already have.

Does this other "low-res" file get assigned a higher or lower value than the AZ Add Pack?

[tgibson]

Just try the low res below the high res layer. If that doesn't work, switch them.

[carlsoti]

Thanks for the reply. I'll futz with it a bit. I spent last night trying to get ANY one of the f-16s to load. I don't remember it being this difficult when I had it all running in the past.