St Pierre Miquelon

[jive1]

I have the scenery of St Pierre and Miquelon in FS2004 and always the LFVM runway is in the water. Whatever I try, I can't have it on land. The spot where the runway is located is not on land but on water....
I installed even the NA72 Simviation Mesh, and nothing helps...
I also tried the FSX-scenery of St Pierre  Miqueln and nothing changed.
WHy is all that so? What can I do to have the Island of Miquelon on land visible instead of unvisible but on a Water surface?
Greetz
Jive1

[Strategic Retreat]

I have FS9 running on the PC on my left, and on LFVM the runway is not on the water. Quite near a little pond that is near a small lake itself, but on solid ground...

Fired up the kids' FSX and... the only difference with FS9 is that the little pond and the lake are connected.

In both cases the runway is on solid ground.

The fact you say it happens to you under FS9 and FSX both is puzzling... or did you try and install a FSX scenery under FS9? I didn't quite get it.

I can only suggest you to try and temporarily exclude all your other scenery add-on and see if it's some sort of conflict.