Simviation Forums

In FSX, if you look to the left of the main screen, you can see the primary options available. Settings, Free Flight, Home Page, Multiplayer, etc.

If you go to the settings tab, you can adjust things like air and sea traffic, graphics levels, and scenery. This part is on the right side.

In "Scenery," you can adjust what FSX prioritizes for scenery. For example, the default configuration makes it very rare to find an airport in the US with jetways at all. By moving the priorities and putting the 3 divisions of the U.S first (East US, West US, and Central US), FSX will produce more scenery in all of North America, and offer a more realistic and detailed flying experience. However, I've noticed an irritating occurence.

No matter how high I turn up scenery after adjusting the scenery priorities, most North American airports still are not completely filled with jetways. At Chicago O'Hare, less than every-other-gate has a jetway. It skips roughly four or five, then puts a jetway with one. Yet for some reason, Hong Kong (VHHH) has jetways at every gate. Why is this? What is happeneing? Why isn't FSX making the "full" decision to place scenery correctly? Why is it only doing it "half-way?" I put North America on the top of the list, and FSX is not showing much of an effect to that nature.

So does anybody have any ideas? Any speculations? Any solutions?!

Anything you guys can come up with is greatly appreciated. Thanks!

Hi,

One guess might be that Hong Kong is a detailed airport (?) in FSX, while most NA airports aren't?

not EVERY airport in the US is "detailed", or even has jetways.


Try flying out of the following airports if you want DETAILED AIRPORTS:

KJFK
KBOS
KLGA
KATL
KLAX
KSEA
KDFW
KORD
KSFO

There is generally at least 1 in every state.  These are just a few that I could think of.   All major airline hubs in the US will be a "detailed" airport, as I am sure that either Microsoft gives money to the major airlines / airport to use their likeness or paint schemes; or it is the other way round.... the airlines/airports give money to Micro$oft to be in the simulator.

NOTICE: I HAVE SINCE EDITED THE ORIGINAL POST. The part about O'Hare was not in there, and I made some small grammatical changes.

Moving on...
But this is the problem, don't you see?

How do I make FSX put Hong Kong, and all the others, on the bottom of the "list?" I don't care about those airports; I want the most possible scenery where I ask for it, and that's obviously not happening! It seriously looks so stupid! Isn't there any way? Anything at all?! Please help!

And riddle me this: If you've seen the scenery files, you know what I'm asking when I ask:

What are all those "Base" files, in the list with the scenery location files? They start at like "Base 0001" and go all the way to somewhere like "Base 1287" or something! What are they for?

Thanks for at least giving this post a look. Keep up the investigation. I'll check back soon, and try to do a little more digging myself.

Thanks for everything so far!

Well, this won't quickly fix all your airports, but can be used to work on a few of your favourites and then go from there. Using ADE (Airport Design Editor), open the deisred airport, highlight any of the parking nodes, then right click, choose "add" and then "Jetway". The item can be positioned as desired as well as the level of scenery complexity at which it displays. Save and compile and it's done.

can ADE be downloaded?

http://www.downloadcenter.scruffyduck.org.uk/

Hope this helps,