Adding Aircraft Traffic, airport gates, etc, to your Sim - AFCAD, TTools, Project AI, AI Aircraft, etc
by B-Valvs » Tue Oct 20, 2009 3:11 pm
For some reason I am no longer able to select FSX in the istaller:
This just started happening. Any ideas?
8-)
Last edited by
B-Valvs on Tue Oct 20, 2009 3:12 pm, edited 1 time in total.
-
B-Valvs
- Lieutenant Colonel
-
- Posts: 5904
- Joined: Mon Aug 24, 2009 7:05 pm
- Location: 5B2
by dave3cu » Tue Oct 20, 2009 5:20 pm
From the WoAI installer doc:
The installer will check the fs9 registry key and when not found you have to tell the installer where your fs9.exe is located via the dialog screen.
Also the installer will look if the FSX registry key can be found. If that is found then you have the opportunity to switch the target where the installer will install the packages (FS9 or FSX).
You could try the FS Registry Repair Tool by Flight1-
http://www.flight1.com/view.asp?page=library-on the chance that your FSX
registry entry is 'broken'.
Dave
Last edited by
dave3cu on Tue Oct 20, 2009 5:22 pm, edited 1 time in total.
At that time [1909] the chief engineer was almost always the chief test pilot as well. That had the fortunate result of eliminating poor engineering early in aviation.
-
dave3cu
- Major
-
- Posts: 3141
- Joined: Sun May 19, 2002 9:55 am
- Location: 3CU, Northern Wisconsin, USA
by B-Valvs » Tue Oct 20, 2009 7:24 pm
I bet that's it. I copied my FSX to a new folder and never updated the regestry. Thanks.
[edit]That did it. Thanks again.[/edit]
8-)
Last edited by
B-Valvs on Tue Oct 20, 2009 8:41 pm, edited 1 time in total.
-
B-Valvs
- Lieutenant Colonel
-
- Posts: 5904
- Joined: Mon Aug 24, 2009 7:05 pm
- Location: 5B2
Return to Adding Aircraft Traffic (AI) & Gates
Who is online
Users browsing this forum: No registered users and 169 guests