Can you describe your problem?
Here's installation instrucion:
MTX System Requirements:
6 GBs of free disk space, FSX capable hardware.
Recommended: Microsoft Dot Net 2.0 or 3.0: MyTrafficX's Communicator and MyTrafficBoard require Microsoft DotNet2. If neither of the MS DotNet libraries are present on your computer and you would like to use the MT-Communicator or MyTrafficBoard - this choice is at the user's discretion - please make sure you install DotNet1 before installing DotNet2.
http://www.microsoft.com/downloads/Sear ... laylang=enMyTraffic Communicator will be started automatically at the end of the install process, it helps you to configure and maintain MyTraffic X. All the functions you get there can also be found in a set of command procedures in the MyTraffic folder, so if for any reason Dot Net cannot be installed to your system, you still can fully enjoy MyTraffic. For installation instructions in this case please go here. This also applies in the case that MyTraffic Communicator does not start at the end of the install process.
If something is unclear, please check our forums before going ahead. In most cases, particular questions will have been answered already.
http://forums.simflight.com/viewforum.php?f=4 MyTraffic X Installation Overview:
- The installation of MyTrafficX runs in two phases
A) a largely automated part which requires little user interaction and
B) two manual adjustments which are necessary to make MyTrafficX come alive in FSX
If you are updating to MyTraffic 5.1 from any running MyTraffic 5.0 installation, the best way is to either remove the
\MyTraffic folder, or to rename it to MyTraffic50 (case you want to keep it, maybe you made some changes) , and to run the installer. No further manual step is required in this case.
MyTrafficX Installation:
A)
Run the MyTrafficX installer 'MTXV5x.exe' by double clicking on it.
This creates the MyTraffic folders and installs all the necessary setup files - Aircraft installers, the database, airport layouts, etc.
