by garymbuska » Sat Oct 13, 2007 5:50 pm
Hello everybody. Well, as the tread says, I'm sick of hand programming my AI. I sthere a program THAT ACTUALLY WORKS available? Payware/Free, either is fine.
I've tried one in the past, but it didn't work. Can't remember what it was.
I do know of any such program, some AI sites like projectai do have a installer that takes all of the hand programing out of it. Other than that I am not aware of a program that allows you to enter data than converts it into a traffic file that TTOOLS could use.
But than again some might have written one it is remotely possible. 8-)
Last edited by
garymbuska on Sat Oct 13, 2007 5:51 pm, edited 1 time in total.
Gary M Buska
SYSTEM Specs ASUS P8Z68 V/GEN 3 mother board: INTELL I7 2600k 3.48 ghz Quad core CPU with Sandy bridge: 12 Gigs of 1800hz ram:
GTX 950 OVER CLOCKED: 2 Gigs Ram Windows 10 Home 64 bit Operating system. 750W Dedicated modular power supply. Two Internal 1TB hard drives 1 External 1TB 3.2 USB hard drive. SAITEK Cessna flight Yoke with throttles.
CH Rudder Peddles 27 inch Wide screen Monitor
