traffic, parking doesn't show at new airport
Posted: Fri Feb 03, 2006 12:51 pmI'm trying to add traffic to an airport which had previously just been a runway (RJTI). I've added the parking spots (all 38 of them!), ran the apron routes, linked everything to the rnuway, and topped it all off wth a pair of red "hold short" nodes. Ran the fault finder and nothing came up.
Then I added the airport to one of my traffic files and using YRoute, gave it a host of traffic.
BUT - when I run FS, I choose the airport as my starting location and the only choices I have for starting out are the ends of the runway. Start the flight anyway and sure enough - no traffic.
I checked to make sure that AFCAD was saving the file in the right folder. What else should I do?
Edited to add: I had just used the same procedure to add a helicopter area to Chofu and that worked fine.
Then I added the airport to one of my traffic files and using YRoute, gave it a host of traffic.
BUT - when I run FS, I choose the airport as my starting location and the only choices I have for starting out are the ends of the runway. Start the flight anyway and sure enough - no traffic.
I checked to make sure that AFCAD was saving the file in the right folder. What else should I do?
Edited to add: I had just used the same procedure to add a helicopter area to Chofu and that worked fine.