Page 1 of 1
Traffic Not Landing
Posted:
Sat Nov 19, 2005 7:54 amby seb
I have setup a default beech baron to do a simple flight in fs2002 it takes off and when it comes back it calls up but then it does three go arounds and on the dissaperars
this is the same with all the flights i have programed although default ones work fine
Re: Traffic Not Landing
Posted:
Sat Nov 19, 2005 12:25 pmby Ijineda
Is the runway blocked? What tool do you use to make your flightplans?
Re: Traffic Not Landing
Posted:
Sat Nov 19, 2005 1:59 pmby seb
No runway is not blocked and i use y-route with ttools
Re: Traffic Not Landing
Posted:
Sat Nov 19, 2005 8:29 pmby Bourgoignie
Hi,
Can you show us an example of your flightplan ?
Second: are you shure there is parking available for your aircraft at the time it will land ?
Greetz. Jos
Re: Traffic Not Landing
Posted:
Sun Dec 04, 2005 11:44 amby curlyo
Hi seb
With regards too your flightplan. Try altering the Barons departure time. However IF there arn't enought ga parking ramps for the aircraft on arrival. Then atc will give it go round instructions. If there still aren't any empty ramps. The baron will disappear' particullarly' if its flightplan is IFR. Also its flight time in the flightplan will have expired, and then it will disapear. Try changing these things. Empty parking ramps could be the worste of your problems. Is the airport a stock airport. If you are still in doubt' them message me.
cheers
Frank.