by dave3cu » Wed Oct 19, 2005 7:38 am
Guess I misunderstood the question in your previous post.
Apparently you are asking about 'boarding bridges', aka 'jetways'. Afcad can not place jetways or any other scenery objects.
To do that requires using a scenery design/placement program(like Airport or FSSC). Check out the 'Scenery & Panel Design' forum.
A few default airports already have jetways, major airports like KLAX, KDEN, etc. To see these jetways the Options>Settings>Display>Scenery Tab>Scenery Complexity must be set to Very Dense or greater.
Dave
At that time [1909] the chief engineer was almost always the chief test pilot as well. That had the fortunate result of eliminating poor engineering early in aviation.
