by garymbuska » Sun Sep 19, 2004 9:55 am
Good question steve. I am not sure if there is a way to do that. The only way it might be possiabel would be to try to assign the other tower view to a different key. Kind of like the way you can use a seperate key to start each engine on a multiple engine aircraft. But I am not sure if that is even possable as I do not know how you could make a new assignment for the other tower view.
I wonder if you could make a XML gauge that would do that.
But even that is going to be a little tricky.
Last edited by
garymbuska on Sun Sep 19, 2004 9:56 am, edited 1 time in total.
Gary M Buska
SYSTEM Specs ASUS P8Z68 V/GEN 3 mother board: INTELL I7 2600k 3.48 ghz Quad core CPU with Sandy bridge: 12 Gigs of 1800hz ram:
GTX 950 OVER CLOCKED: 2 Gigs Ram Windows 10 Home 64 bit Operating system. 750W Dedicated modular power supply. Two Internal 1TB hard drives 1 External 1TB 3.2 USB hard drive. SAITEK Cessna flight Yoke with throttles.
CH Rudder Peddles 27 inch Wide screen Monitor
