Simviation Forums

Just wondering if there's somthing I could use to get rid of trees in AFCAD. I'm making an airport that M$ left out, cause all it is, is a ballooning and helo tour spot. And the place where I put it has many trees, and when I go to test it in FS, it comes up like this...





So anything? Or do I have to find a spot where there's no trees? That's in its real location... When it's done, I'll upload it to SimV... It's my first scenery upload... Err... Any upload for that matter!

~James

P.S.- I musta had an oil leak in my Stearman...

Hey James - just put a little exclude over the area where you have your scenery and all your problems will be little ones

If you need to know how, there was a thread either here or in the scenery folder just a short while ago

Flyboy  The thread RollerBall is talking about is an the bottom of this page. Just look for exluding and flattening switches by me.

PS listion to RollerBall, he knows AFCAD, sure has helped me.