A question from Fly2e And......An Answer from TJ!!
Posted: Wed Nov 12, 2003 10:33 amHey guys, I rarely visit here but I was wondering if I could get some help.
When I had FS2002, I downloaded the AI package from ProjectAI. The installer and about 20 airlines. I opened up the installer, then the airline file and bam...the aircrafts were flying all over the place. I loved it, simple and easy.
I waited until recently to get the FS2004 upgrade version. The other day I downloaded the "special packages", the FS2004 Default Commercial Traffic Installer, the
FS2004 Default General Aviation Traffic Installer, and the
FS2004 Default Vintage Traffic Installer. I also installed the FS2004 installer along with the Jetblue and Southwest airlines file because when I had fs2002 and ProjectAI, these aircraft were always abundant near my home town airports, Islip's Mc Arthur and JFK and it was easy to test to see if they were there.
Since using the new installer and airline file, I cannot get any ProjAI aircraft to show up. The planes are all in my FS2004 aircraft file, but they do not show up at any airports. My regular default AI are there, but not the project AI. The installer runs and says suucessful. I remember in 2002, the compiler would run durring the install of the airline, I do not see this happening, I do however so a new thing happening, a window which is moving things from one place to another.
Any help would be appreciated.
Thanks!!
When I had FS2002, I downloaded the AI package from ProjectAI. The installer and about 20 airlines. I opened up the installer, then the airline file and bam...the aircrafts were flying all over the place. I loved it, simple and easy.
I waited until recently to get the FS2004 upgrade version. The other day I downloaded the "special packages", the FS2004 Default Commercial Traffic Installer, the
FS2004 Default General Aviation Traffic Installer, and the
FS2004 Default Vintage Traffic Installer. I also installed the FS2004 installer along with the Jetblue and Southwest airlines file because when I had fs2002 and ProjectAI, these aircraft were always abundant near my home town airports, Islip's Mc Arthur and JFK and it was easy to test to see if they were there.
Since using the new installer and airline file, I cannot get any ProjAI aircraft to show up. The planes are all in my FS2004 aircraft file, but they do not show up at any airports. My regular default AI are there, but not the project AI. The installer runs and says suucessful. I remember in 2002, the compiler would run durring the install of the airline, I do not see this happening, I do however so a new thing happening, a window which is moving things from one place to another.
Any help would be appreciated.
Thanks!!
Cheers!
theres still time to nip accross the grass onto the runway before the plane lands!! ;)