Adding Aircraft Traffic, airport gates, etc, to your Sim - AFCAD, TTools, Project AI, AI Aircraft, etc
by FSFLYER2 » Wed Nov 14, 2007 11:40 am
Videokid? Ihave had MS FltSim since wire frames FS4 and have never seen that error window! So I would promt that this window is unusual?
good luck
-
FSFLYER2
- 2nd Lieutenant

-
- Posts: 129
- Joined: Wed Jan 31, 2007 4:57 pm
- Location: UK Sth Lancs
by Groundbound1 » Wed Nov 14, 2007 11:54 am
I could be wrong (and I probably am!) but I think some World of AI packages need different versions of that installer. You do have .NET framework 2.0 installed correctly right?
Last edited by
Groundbound1 on Wed Nov 14, 2007 1:23 pm, edited 1 time in total.
-

Groundbound1
- Major

-
- Posts: 1670
- Joined: Fri Nov 09, 2007 10:59 am
- Location: Michigan, USA
by Hagar » Wed Nov 14, 2007 11:58 am
I haven't tried the World of AI package so can't help with that error message. My first suggestion is to make sure you read the instructions carefully & have all the required files.
http://www.world-of-ai.com/installerIf all else fails try their support forum.
-

Hagar
- Colonel

-
- Posts: 30862
- Joined: Wed Jun 19, 2002 7:15 am
- Location: Costa Geriatrica
-
by f14driver » Thu Nov 15, 2007 5:37 am
Posted: Wed Nov 14,2007 13:49 13 Post subject:
--------------------------------------------------------------------------------
First of all, read the installer readme and look at the installer setup page.
Secondly, make sure you have all the files that come with the installer are in the same directory.
if the above is already the case then please redownlaod the installer again and see it this problem happens agan.
DO NOT MOVE ANY FILE THAT COMES WITH THE DOWNLOAD OUTSIDE THE FOLDER YOU UNZIP THE INSTALLER TO.
Airline packages do not need unzipping.
You can install them straight from the zip file when you download them.
-

f14driver
- 2nd Lieutenant

-
- Posts: 62
- Joined: Wed Oct 02, 2002 1:45 pm
- Location: NL
-
Return to Adding Aircraft Traffic (AI) & Gates
Who is online
Users browsing this forum: No registered users and 289 guests