by garymbuska » Wed May 25, 2005 2:08 pm
When you first open AFCAD it will be blank just click on the open airport and it will load up all of your active airports you can then enter the ICAO or use the menu to select the region/state/city/than the airport you want to open. After your airport is open you can than make any changes you want and than save your work. I would suggest you save any AFCAD files in a folder called AFCAD or whatever you like in the ADDON SCENERY FOLDER. Rember you will have to activate the scenery using the add scenery tab or it will not show up.
Just make a folder called AFCAD and then a folder within AFCAD called scenery and put all of your afcad files here. That way any other files you add will be generated when you start up FS.
Gary M Buska
SYSTEM Specs ASUS P8Z68 V/GEN 3 mother board: INTELL I7 2600k 3.48 ghz Quad core CPU with Sandy bridge: 12 Gigs of 1800hz ram:
GTX 950 OVER CLOCKED: 2 Gigs Ram Windows 10 Home 64 bit Operating system. 750W Dedicated modular power supply. Two Internal 1TB hard drives 1 External 1TB 3.2 USB hard drive. SAITEK Cessna flight Yoke with throttles.
CH Rudder Peddles 27 inch Wide screen Monitor
