Print view
Board index ‹ Current Flight Simulator Series ‹ Adding Aircraft Traffic (AI) & Gates

Runway

Adding Aircraft Traffic, airport gates, etc, to your Sim - AFCAD, TTools, Project AI, AI Aircraft, etc
Post a reply

Runway

Postby YSSY » Fri Aug 20, 2004 6:16 am

I recently installed  a new AFCAD file for YSSY. The problem is that since it has been installed, aircraft have been taking off on the wrong runway for wind conditions. For example winds are 345/ 24 but aircraft air departing on 16l/16r instead of 34l/34r. I have most realistic AI installed as well, with many carriers as part of my new AI traffic.
YSSY
Ground hog
Ground hog
 
Posts: 1
Joined: Fri Aug 20, 2004 7:06 am
Top

Re: Runway

Postby garymbuska » Fri Aug 20, 2004 2:36 pm

Afcad Updates to existing runways are visual only FS will not use any added ILS runway without including a seperate bgl file that updates the orignal bgl file than fs will use the new ILS runways in bad weather.
I have seen several people that have updated a orignal airport by using AFCAD to make the new ILS runways than use xml to create a new bgl file to allow fs to use them. Check out AVSIM.
AT least this is what i think they are doing. It makes sense to me but I could be wrong 8)
Gary M Buska
SYSTEM Specs ASUS P8Z68 V/GEN 3 mother board: INTELL I7 2600k 3.48 ghz Quad core CPU with Sandy bridge: 12 Gigs of 1800hz ram:
GTX 950 OVER CLOCKED: 2 Gigs Ram Windows 10 Home 64 bit Operating system. 750W Dedicated modular power supply. Two Internal 1TB hard drives 1 External 1TB 3.2 USB hard drive. SAITEK Cessna flight Yoke with throttles.
CH Rudder Peddles 27 inch Wide screen Monitor
User avatar
garymbuska
Major
Major
 
Posts: 4415
Joined: Tue Dec 30, 2003 11:10 am
Location: Jacksonville, Florida
Top
Post a reply

Return to Adding Aircraft Traffic (AI) & Gates

Who is online

Users browsing this forum: No registered users and 266 guests