by garymbuska » Tue Jul 20, 2004 12:35 pm
after you run ttools it will give you a list of the airports that are in the flight plans look through these to see if your airport is listed. The PAI Plans can sometimes be old and may not include your airport.
You can always edit the list to add your airport and the plane of your choice.
Also make sure your AI traffic slider is set high enough to see the traffic at least 80 % or above. You also have to rember that these flights run on specific times so it is possable to not see any AI of a specific type at certain times as they are either outbound or inbound at the time you are there.
Gary M Buska
SYSTEM Specs ASUS P8Z68 V/GEN 3 mother board: INTELL I7 2600k 3.48 ghz Quad core CPU with Sandy bridge: 12 Gigs of 1800hz ram:
GTX 950 OVER CLOCKED: 2 Gigs Ram Windows 10 Home 64 bit Operating system. 750W Dedicated modular power supply. Two Internal 1TB hard drives 1 External 1TB 3.2 USB hard drive. SAITEK Cessna flight Yoke with throttles.
CH Rudder Peddles 27 inch Wide screen Monitor