I programmed a flight using TTOOLS from SLLP (El Alto Itl, in La Paz, Bolivia) to SPZO (El Cuzco, in Peru). I was able to see the flight progress, from taxiing and take off, I basically chased the flight until it got up to its cruising altitude of 31000 ft, at that point ATC issued its standard warning "flight 921,you are 300 ft below your assigned altitude, climb and maintain...etc,", two more warnings and radar service was terminated. The flight started to behave erradically, like, making altitude corrections of about 1000 ft throughout the flight, and about 50 miles from Cuzco the AI flight just veered to the left and dissapeared. I landed with my airplane in Cuzco, no AI plane on the ground, I changed the time back to see if I could see it land..nothing. I changed the time again to its scheduled departure time, but the AI airplane never showed up at the airport. Is there an explanation to this?. I will see if I can see it returning to SLLP. I'll sit at the end of the runway and I'll wait to see if it arrives and not simply "pop-up", because I can see the airplane sitting at the terminal after its scheduled arrival time. Thanks for trying to make some sense out of this. Hernan
