Page 1 of 1

FREE ATC for FS Host!

PostPosted: Tue Mar 17, 2009 6:32 am
by TGI-245
I wonder if anyone could assist me.  I am curently looking for free ATC software that can be used on the FS Host Client that will not only show FSX but FS2004 aircraft.

Many Thanks in advance

Re: FREE ATC for FS Host!

PostPosted: Tue Mar 17, 2009 5:59 pm
by Capt.Propwash
that would be, ATC RADAR SCREEN v.5 see below for a sample pic.


8th one down
http://www.simviation.com/fs2004utilities3.htm

MUST HAVE 9TH ONE DOWN BEFORE YOU INSTALL ATC RADAR SCREEN!!!


FS2004/2002 ATC Radar Screen v5.0 This program will allow you to control a towered-airport or an entire ARTCC/FIR's sector, in a multiplayer session. Features: view jet airways, victor airways, new SID/STARs window, edit ATIS message, view additional airspaces (ONLY FS2004 users), etc. Doesnt requires any earlier version. Requires the Manuel's Service Pack 3 (below) . By: Manuel Ambulo. 3.3MB


!!!!!!!!!! IF YOU GET THIS...... WHEN YOU GO TO CONNECT TO THE FS HOST MULTIPLAYER..... IT IS AN FS 2004 SESSION!!! NOT A FS 2002 SESSION!!!!!!!!!!

you can ATC from any airport in the world as long as it has a tower!!, or from any AIRSPACE (dont need a tower)... if you choose airspace, you see EVERY airport in your sector and you CONTROL all of them if there is no atc at that airport..... or you control just the airspace above the airports.. whatever you choose to do.

Re: FREE ATC for FS Host!

PostPosted: Tue Mar 17, 2009 7:14 pm
by TGI-245
thanks a lot.  I noticed that FS 2004 and 2002 is mentioned but not FSX.  Does it work with FSX also?

Re: FREE ATC for FS Host!

PostPosted: Tue Mar 17, 2009 7:49 pm
by Capt.Propwash
in the short.... YES.  If you do have FS HOST CLIENT, you do not need to start it to run ATC R.S. .. Host Client is only for FSX to connect to FS HOST.


4 programs are needed.

1) FS HOST (session)

2) FS HOST CLIENT - if you plan on flying in FSX

3) ATC Radar Screen 5

ATC R.S. 5 connects to the HOST.  FS 2004 connect to the HOST. FS "X" CLIENT (#2) connects to the HOST.  If you do have FS HOST CLIENT, you do not need to start it to run ATC R.S. .. Host Client is only for FSX to connect to FS HOST.

ATC R.S. sees everyone, everyone sees everyone EXCEPT for ATC (you are in the tower)

Re: FREE ATC for FS Host!

PostPosted: Wed Mar 18, 2009 4:51 am
by TGI-245
Thank you very much for your assistance, i will have our Chief Technical Officer to take a look at it.

Many Thanks once again

Re: FREE ATC for FS Host!

PostPosted: Fri Mar 20, 2009 9:38 pm
by lunitic_8
[quote]in the short.... YES.

Re: FREE ATC for FS Host!

PostPosted: Sat Mar 21, 2009 7:31 am
by Capt.Propwash
depends on what is inside it.... lol

Image

Re: FREE ATC for FS Host!

PostPosted: Mon Mar 23, 2009 6:18 pm
by lunitic_8
depends on what is inside it.... lol

Image

 ROFL!! ;D ;D