Page 1 of 1

Can some help me out

PostPosted: Tue Jan 16, 2007 11:25 pm
by Tjw2
will someone make a cropduster with a working spray effect

Re: Can some help me out

PostPosted: Wed Jan 17, 2007 12:18 am
by Isak922
http://simviation.com/fs2004helicopters31.htm Schweizer 300C Crop Duster. It's a helo, but it's still a cropdusting aircraft  ;D

Re: Can some help me out

PostPosted: Wed Jan 17, 2007 2:08 pm
by Travis
And with a little knowledge and help, you can get any cropduster that you find (like an Airtractor) to have that same effect.

Re: Can some help me out

PostPosted: Wed Jan 17, 2007 7:31 pm
by Tjw2
i have had the helecopter but when i put the effect on the airtractor it sprays veritcle above and under the wing

Re: Can some help me out

PostPosted: Fri Jan 19, 2007 2:13 am
by Travis
You have to adjust the numbers that are in the aircraft config under the heading [smokesystem].  I don't know what they should be, but they are coordinates for the emitter point of the effect.  You can adjust the vertical and horizontal points in the aircraft config, but the fore and aft point has to be changed in the effect file itself.

Re: Can some help me out

PostPosted: Fri Jan 19, 2007 11:27 am
by FSGT Gabe
Here is how you adjust the smokesystem:

The numbers, like Locke said, are the coordinates for where the emitter point is.  The first tells you have far above or below the reference point it is, the second tells you how many feet back or forward, and the third tells you how much left or right it is.  For example:

smoke.0=1.5,-11.0,-8.0,fx_smoke_w

...would be 1.5 feet above the ref point, 11 feet back, and 8 feet to the left.  You can adjust them however you want in the aircraft.cfg.

- Kevin ;D

Re: Can some help me out

PostPosted: Thu Jan 25, 2007 10:00 pm
by Tjw2
I might seem stupid but i dont know how to do this i dont have the deluxe edditon but if i can do this i would like step by step directions here
Thanks