Take a look, can we build one?

[cspyro21]

Lol...maybe I should stay out of aircraft designing.....  ;)

[Skligmund]

Wow. I haven't been flying Flight Sim for more than a month now! I've been really busy at work and getting things done before winter sets in.
I'm sorry for not updating anything recently. I've been working on a PA-31T1 at work, and I'm going to take photos of the interior for you guys. It is basicly the same aircraft (same PT6A-11's) and panel, so it should help out a lot.
I don;t have any recording equipment, so I can't get a recording when we run it up. Had I known this aircraft would be here, I would have been more prepared.

Also in T-1040 news:

Frontier Flying Service merged/purchased Cape Smythe Air, who owned/owns anywhere from 2 to 4 T-1040's (FAA Register says 4 [one research and developement], another employee says 2). As I still have a 'part time' employment at Frontier, I should be able to bum a ride on a 1040 in the not too distant future. During this time, I'm going to record, photo and remember anything I can.

[GWSimulations]

Also in T-1040 news:

Frontier Flying Service merged/purchased Cape Smythe Air, who owned/owns anywhere from 2 to 4 T-1040's (FAA Register says 4 [one research and developement], another employee says 2). As I still have a 'part time' employment at Frontier, I should be able to bum a ride on a 1040 in the not too distant future. During this time, I'm going to record, photo and remember anything I can.

If you canget sounds of the following things then I should be able to make a custom soundpack for it:
 -Engine Start
 -Engines Running at Full & Idle
 -Engine Shutdown
 -Gear Deploy/Retract
 -Flaps Deploy/Retract

Thanks.

[Skligmund]

I'll see what I can do. It seems the Cheyenne will be around for a bit longer, it has a fuel cell leak, and may take some time to repair. I hope I can get my act together and get those sounds.


Thanks!