Page 1 of 1
737-800 Panel With Trinkets
Posted:
Sun Mar 25, 2012 10:39 pmby BobF
I downloaded and installed the 737-800 Panel with Trinkets by Skilaeb Dygsbi here today. There is no e-mail for Skilaeb. I get an error when trying to use the HUD. It says configuration error - Check your ini file. The entry in the panel.cfg is:
HUDCA$/config!config, 0,0,,, ./gauges/HUDCA$/B737config.ini
I don't know what this is as there is no HUDCA$/config gauge or any ini entry. Thanks, Bob.
Re: 737-800 Panel With Trinkets
Posted:
Tue Mar 27, 2012 12:12 amby Webb
For now you can REM out that line by putting // in front of it.
Re: 737-800 Panel With Trinkets
Posted:
Tue Mar 27, 2012 12:32 amby BobF
Hi. Thanks. If I rem it out will the HUD work OK? Regards, Bob.
Re: 737-800 Panel With Trinkets
Posted:
Tue Mar 27, 2012 12:41 amby Webb
Everything should work the same as it does now but without the error message. That line of code isn't doing anything anyway.
I didn't install the panel. I just downloaded it and examined the code. It's a pretty obvious mistake.
Re: 737-800 Panel With Trinkets
Posted:
Tue Mar 27, 2012 10:17 amby BobF
HI. OK. Thanks. I'll try it. Regards, Bob.
Re: 737-800 Panel With Trinkets
Posted:
Tue Mar 27, 2012 2:30 pmby BobF
[quote]Everything should work the same as it does now but without the error message.