Page 1 of 1
Having trouble with a design
Posted:
Wed Jan 20, 2010 6:54 pmby Censport
I'm working on RODN - Kadena Air Base in Japan. No matter what I do, I cannot get planes to take off on 5R. They just sit there until they disappear. I've run it through the Fault Finder on both AFCAD and ADE. ADE told me that the hold-short node was too far from the runway, so I moved it until it cleared the Fault Finder. Still no go. I changed the hold-short node to a normal node. Still no go.
Suggestions?
Re: Having trouble with a design
Posted:
Wed Jan 20, 2010 6:59 pmby skoker
Increase traffic scalar?
Re: Having trouble with a design
Posted:
Wed Jan 20, 2010 8:08 pmby Censport
Increase traffic scalar?
*
whoosh* Right over my head. What is that, and how do I adjust it?
Re: Having trouble with a design
Posted:
Thu Jan 21, 2010 12:09 amby Censport
I put a normal node just behind the hold-short node, and now some of the aircraft are taking off from 5R. Not all, but some.
Re: Having trouble with a design
Posted:
Thu Jan 21, 2010 4:31 pmby ShaneG_old
Maybe an obvious issue, but is the weather VFR or IFR during testing. I've had AI sit forever waiting on the skies to clear.
Re: Having trouble with a design
Posted:
Thu Jan 21, 2010 4:45 pmby Censport
That occurred to me late in the process, but I did go back and check my flight plans. Still testing...