Page 1 of 1

EZ Scenery and FS9 CTD

PostPosted: Sun Feb 03, 2008 12:32 am
by Dan Morera
I made an object using FSDS 3, saved it as a .mdl  then using the EZ Scenery I followed the steps to create mylibrary and mylibrary.bgl, but the problem is this:

I open FS9, start EZ Scenery, I can select from the library list "mylibrary"   but the minute I position the cursor on top of the object my hard drive starts working and my FS9 goes to a black screen and ctd.

What am I doing wrong?

Thanks
Dan

Re: EZ Scenery and FS9 CTD

PostPosted: Mon Feb 11, 2008 1:07 pm
by Fozzer
..just in case you didn't know, Dan...

There are lots of "EZ-Scenery" library objects available from Avsim...>>>

http://library.avsim.net/search.php?Sea ... &Go=Search

Try their Forum for answers to "EZ" problems...;)...!

Paul...LAGO FSE, and EZ-Scenery user... 8-)...!

Re: EZ Scenery and FS9 CTD

PostPosted: Wed Feb 13, 2008 4:44 pm
by Dan Morera
Thank you sir. Just one follow up question can I modify those objects? Can I do it using FSDS 3.0?

Thanks Again
Dan

Re: EZ Scenery and FS9 CTD

PostPosted: Wed Feb 20, 2008 3:35 am
by commoner
..just in case you didn't know, Dan...

There are lots of "EZ-Scenery" library objects available from Avsim...>>>

http://library.avsim.net/search.php?Sea ... &Go=Search

Try their Forum for answers to "EZ" problems...;)...!

Paul...LAGO FSE, and EZ-Scenery user... 8-)...!


.Hi Fozz.....new convert to EZ Scenery and would like to know if there are any taxiway and runway signs for this utility........I've Googled 'til I'm daft but can't find any.........I'm having to "paint" over other signs to do this and it's a bit of a nuisance..........don't like following the purple arrows and keep getting lost........

Cheers...commoner  ;D

Re: EZ Scenery and FS9 CTD

PostPosted: Sun Mar 23, 2008 10:29 pm
by homebrewer
I can't get my EZ-Scenery to do anything. I click on the link in the screen that comes up when you launch it, and I get zilch. It has been a long time since I tried it, but I remember it went nowhere...

Re: EZ Scenery and FS9 CTD

PostPosted: Wed Mar 26, 2008 3:19 am
by commoner
I can't get my EZ-Scenery to do anything. I click on the link in the screen that comes up when you launch it, and I get zilch. It has been a long time since I tried it, but I remember it went nowhere...


..not sure if I read you right but EZ Scenery is "launched" from inside FS9...mine has an Abacus entry on the top tool bar in "FS9 Window mode"

...any help?...commoner ;)