XLM gauge - can a variable control an event?
Posted: Tue Feb 19, 2008 3:03 pmHello everybody,
I'm trying to make an auto-lean / auto-reach mixture handle. I'm sure i'm not the first one, but i can't find anything about it.
So I was wondering if there is a way to make a variable control an event, like :
if (this is my fuel/air ratio) > (this is the good fuel/air ratio for my altitude and outside air temperature) then DECREASE MIXTURE
OK, this is not a good XML code, but you might see what i mean?
Of course there is the auto mixture option, but i want 4 positions: IDLE CUT-OFF, AUTO-LEAN, AUTO-RICH, EMERGENCY, like in the A-20 Havoc.
I have a gauge for the L10E Electra showing if mixture is too lean or rich, so it is possible to have a variable that gives the good fuel/air ratio. But is it possible to have events depending on this variable.
It's a bit hard for me to explain this in english, so if i'm not clear just tell me.
thanks for all!
I'm trying to make an auto-lean / auto-reach mixture handle. I'm sure i'm not the first one, but i can't find anything about it.
So I was wondering if there is a way to make a variable control an event, like :
if (this is my fuel/air ratio) > (this is the good fuel/air ratio for my altitude and outside air temperature) then DECREASE MIXTURE
OK, this is not a good XML code, but you might see what i mean?
Of course there is the auto mixture option, but i want 4 positions: IDLE CUT-OFF, AUTO-LEAN, AUTO-RICH, EMERGENCY, like in the A-20 Havoc.
I have a gauge for the L10E Electra showing if mixture is too lean or rich, so it is possible to have a variable that gives the good fuel/air ratio. But is it possible to have events depending on this variable.
It's a bit hard for me to explain this in english, so if i'm not clear just tell me.
thanks for all!