FSSC, Airport 2.*, CfgEdit, etc. Get to grips with designing Scenery & Panels here!
by GunnerMan » Mon May 28, 2007 4:40 pm
Well it is a well know issue that the way FS renders airports is on a flat surface so when you have addon mesh some airports end up on a mesa or in a hole. Now my hometown airport is on about a 20 - 50 foot mesa on 3 sides. Most of the time I see an airport like this and it dosen't bother me because I will prolly never see it again so is there a way to adjust the elevation of the airport to better blend with the surrounding terrain?
-
GunnerMan
- Major
-
- Posts: 1485
- Joined: Wed Dec 11, 2002 12:38 am
- Location: In The Cockpit
by Solid » Fri Jun 01, 2007 4:53 pm
Sure.....Sbuilder gives you all the needed tools to do that and then you just make a new airport with AFCAD or a similiar tool.
Gera
-
Solid
- 1st Lieutenant
-
- Posts: 351
- Joined: Fri Jun 01, 2007 5:40 pm
- Location: Panama
-
by GunnerMan » Fri Jun 01, 2007 8:57 pm
IS this all FSX compatible? Thanks!
-
GunnerMan
- Major
-
- Posts: 1485
- Joined: Wed Dec 11, 2002 12:38 am
- Location: In The Cockpit
by GunnerMan » Fri Jun 01, 2007 9:18 pm
Ok I found the Sbuilder for FSX and it seems easy enough but when I change the airfields altitude and try to recompile it I get a message saying "the file could not be found"
Last edited by
GunnerMan on Fri Jun 01, 2007 10:10 pm, edited 1 time in total.
-
GunnerMan
- Major
-
- Posts: 1485
- Joined: Wed Dec 11, 2002 12:38 am
- Location: In The Cockpit
Return to Scenery & Panel Design
Who is online
Users browsing this forum: No registered users and 144 guests
