ADS-B Gauge

Posted:
Thu Nov 09, 2006 7:55 pm
by Gringo6
The hot news from UPS is that they will have their entire fleet of 757/767 equipped with ADS-B (Automatic Dependent Surveillance-Broadcast) by the end of 2007.
This looks like a natural for FlightSim gauge builders.
Has anybody made one? or working on one ? Sure would like to know.
Billa (aka Gringo6)
Re: ADS-B Gauge

Posted:
Tue Nov 21, 2006 10:51 am
by Gringo6
No response!!
Did I post this to the wrong forum ? ? ?
BillA (aka Gringo6)
Re: ADS-B Gauge

Posted:
Tue Nov 28, 2006 5:24 pm
by swordfish1227
Im not sure exactly what you sre talking about, could you explain better or provide a link?
p. s. don't worry, sometimes it takes a while in these design forums.
Re: ADS-B Gauge

Posted:
Tue Nov 28, 2006 9:41 pm
by Gringo6
Ok Swordfish 1227- ADS-B is a gauge. The face of it looks like the Garmin GPS. But it works different.
It is mostly used for airplanes on the ground at busy airports; and in lousy weather conditions it will help prevent collisions between taxiing airplanes. When equipped with an overlay for a particular airport it shows taxi-ways, etc. You can taxi in zero visibility with
reasonable confidence that you'll get where you want without running into anything. If the fuel trucks on the tarmac are equipped with ADS-B they'll show up on the screen too. I suspect that running over a loaded fuel truck, with the resulting fire, would ruin your whole day.
The way it works is all ADS-B equipped aircraft xmit their position derived from their GPS to a central place on the airport There positions of ALL these aircraft (along with identifiers etc) are re-broadcast on a common frequency to ALL other airplanes (ADS-B equipped or not). That way everybody with an ADS-B receiver know where all the ADS_B aircraft are located.
If you don't have an ADS-B transmitter you won't show up on the screens of the other airplanes. If you have a receiver (but no transmitter) you will know where they are (but they won't know where you are).
I tried to use the F-16 radar set for this but it only shows airplanes in flight, and doesn't show those on the ground, taxiing, etc. It does give a readout on the model, airline, etc. however. The range is way too great but this could be reduced I bet. The thing works off of FSUIPC so a smart "gauge-man" could program it to show ranges closer to your airplane
If the F-16 radar could be modified to show all airplanes, instead of only those in flight, and at closer range it would do the trick.
This isn'y any big earth-rocking thing, but since it is so-o-o similar to the F-16 radar I thought it might be in somebody's play-book for a future gauge.
It would look neat on the panel, too.
Billa (aka Gringo6)
Re: ADS-B Gauge

Posted:
Wed Nov 29, 2006 5:30 pm
by swordfish1227
the f-16 gauge can be zoomed in, there are click points to do just that. there are also 2 other views other than the circle; the cone and the vertical height relation one.
this one will show all moving aircraft and also static aircraft with a switch on it.
http://www.avsim.com/ search for "AI Radar, Traffic Collision Avoidance System"
I think this is as close as you can get to an ads-b gauge.