FSSC, Airport 2.*, CfgEdit, etc. Get to grips with designing Scenery & Panels here!
by bradwp2002 » Thu Aug 24, 2006 12:11 am
Trying to create exclusion zone with bglcomp.exe, whenever I set any of the exclusions to "True" I get an error and the .bgl is not created. If exclusions are "False" it works fine (which does me no good). Any thoughts, or theories. I have even tried ExcBuilderV2 and it still doesn't work.
Thanks
Brad
-
bradwp2002
- Ground hog
-
- Posts: 2
- Joined: Thu Aug 24, 2006 12:52 am
by dave3cu » Thu Aug 24, 2006 7:14 am
What errors are you getting?
Did you install the MSXML 4.0 Parser? (Req.by Bglcomp)
Dave
At that time [1909] the chief engineer was almost always the chief test pilot as well. That had the fortunate result of eliminating poor engineering early in aviation.
-
dave3cu
- Major
-
- Posts: 3141
- Joined: Sun May 19, 2002 9:55 am
- Location: 3CU, Northern Wisconsin, USA
by bradwp2002 » Thu Aug 24, 2006 3:23 pm
Nevermind, I'm a complete idiot. I had the longitudes swapped. Thanks for the help though. (when copying the error message I saw the light "ERROR C2345: LongitudeMinimum MUST be less than LongitudeMaximum!") Wish I had noticed that last night.
-
bradwp2002
- Ground hog
-
- Posts: 2
- Joined: Thu Aug 24, 2006 12:52 am
by Katahu » Fri Aug 25, 2006 4:44 pm
Nevermind, I'm a complete idiot. I had the longitudes swapped. Thanks for the help though. (when copying the error message I saw the light "ERROR C2345: LongitudeMinimum MUST be less than LongitudeMaximum!") Wish I had noticed that last night.
It happens all the time. Also make sure that you have proper spacing and proper case as the compiler is very strict with that.
-
Katahu
- Lieutenant Colonel
-
- Posts: 5993
- Joined: Mon Jul 22, 2002 10:29 pm
Return to Scenery & Panel Design
Who is online
Users browsing this forum: No registered users and 183 guests
