Simviation Forums

How do I use Rwy12?

Ive read the readme and instructions but I don't understand?

Im not in front of my computer so im writeing this from memory.



After it is installed start FS go into slew mode overhead veiw.
Start Rnwy12  link to FS position then select object you want to place alt-tab back to FS and slew to where you want the object then alt-tab back to Rnwy12 and place object.

as i said not in front of the computer that has it installed so it kinda vague but gives the idea of what to do.

Each of us operates at varying levels of comprehension so may I suggest if Rwy12 Readme is over-your-head pony-up $29 bucks and get EZ-SCENERY

After installing Rwy12 correctly and receiving tips from other users at the Rwy12 Forum I found the instrucitons given on the Opening Screen sufficient to place RWy12 Objects in FS9.

Good Luck



The Rwy12 FAQ can be read in this Acrobat Reader PDF file

First of all make sure you have it set up properly. It looks a tad complicated to me. http://www.rwy12.com/download/tutorials/rwy12_op_faq.pdf

You need Adobe Reader installed to read the above link.

First of all make sure you have it set up properly. It looks a tad complicated to me. http://www.rwy12.com/download/tutorials/rwy12_op_faq.pdf

You need Adobe Reader installed to read the above link.

All you Ol' Fogies think new technology is too complicated.

I bet you hate to use those "new-fangled" glass cockpits, too, huh?

All you Ol' Fogies think new technology is too complicated.

I bet you hate to use those "new-fangled" glass cockpits, too, huh?

What I meant was - complicated for a beginner to understand, assuming that masmith is new at this.