Simviation Forums

I am using custom panel designer from abacus and i keep getting:
run-time error 9
Subscript out of range.
I went to the abacuspub website but could not find any info on error codes.
Is there a forum directly relating to Abacus products?

Also i wanted to add an Avionics Master switch to the default Lear 45 Panel and when i opened it in CPD the gauges were all the wrong sizes ands when isaved it after adding the switch the gauges were in the wrong sizes although they were ok before adding the switch. I don't have any problems with other panels in the way they display only the Lear45

Any ideas Please
Thanks Allen

Open the panel.cgf file with Notepad (after backing it up).

Add this line to the main panel window  (  [Window00]  ):


gauge34=Cessna208!Avionics-Switch, 22, 99

It puts it nicely on the upper-left, out of the way but obvious.

Thanks Brett,
I will do that. I am surprised that all aircraft don't have an avionics switch. but iam still trying to find out why these errors are happening.
Allen