Page 1 of 1
FSSC Complie Problem
Posted:
Fri Dec 03, 2004 3:12 pmby brittair
I need help. I had been making some minor changes to a FSSC project (just taixlines) and when I went to use the auto export I got this error message:
Error in line 736
-> Poly( au 0 1 2 3 4 5 6 7 8 )
-> corrupted polygon, check points and point list!
Scasm compilation status: error(s) 1
What does it mean??
Re: FSSC Complie Problem
Posted:
Wed Dec 08, 2004 7:45 amby brittair
Come on there must be someone out there with an idea????
I am really p***ed as I was just about ready to get this project tested,please help!!!!
Re: FSSC Complie Problem
Posted:
Wed Dec 08, 2004 9:43 amby bm
Could it mean that the points of the polygon cross at some point? Sometimes an error occurs when there are too many points in a polygon. If you can remember editing a particular polygon try removing a few points and checking they don't cross at any points.
Thats all I can think of I'm afraid.
Birdman.
Re: FSSC Complie Problem
Posted:
Wed Dec 08, 2004 10:45 amby brittair
Thanks for your suggestion Bird man. I will give it a try and see what happens.
It may take a wee while as thinking back when I was adding the taxilines I was making minor adjustments to the Hardened Aircraft Shelter bases..... all 20 of them.
Re: FSSC Complie Problem
Posted:
Mon Dec 13, 2004 11:32 amby brittair
Found it!! Thanks for your suggestion Birdman
Re: FSSC Complie Problem
Posted:
Mon Dec 13, 2004 2:18 pmby bm
Glad you fixed it! Always a damn nuisance thats for sure when that happens.
What scenery are you making? Sounds large
Thanks,
Birdman.
http://www.simviation.comRe: FSSC Complie Problem
Posted:
Mon Dec 13, 2004 3:31 pmby brittair
I am doing a version of RAF Leeming in N Yorks, England.
Couple of images below
(do not seem to be working so here are the links
http://www.simviation.com/yabbuploads/brittl.jpg and
http://www.simviation.com/yabbuploads/brittle.jpg)
Just about ready for someone to test.
Re: FSSC Complie Problem
Posted:
Mon Dec 13, 2004 5:30 pmby bm
There ya go! Looks nice. What sim is it for? I could give it a little run over if you like but I can only do FS2004.
Birdman
Re: FSSC Complie Problem
Posted:
Tue Dec 14, 2004 3:34 amby brittair
Sorry Bird man but it is for FS2002, but thanks for the offer.
I used FSSC with FSDSv2 for macros. I am about to install FS2004, any idea if FSSC is can export for FS2004?