Simviation Forums

hey guys! i have been tryin to figure this one out for a while now, but just cant seem to do it. I am using a C152 with default panel, the one from carensoemthin, if you are looking any dirrection but strait ahead you look at both the virtual cocpit, and the normal 2D one. I sorta like the 2D one better (photorealistic) and would like to get rid of teh virtual cocpit, any ideas on what i need to change to do this???


Squeek (aka USAFauxilary)

hey guys, nvm, but i think i am gona leave the solution here, incase anyone else ever needs it. What you do is change the [Default View] thing. just make Size_X=0 and Size_Y=0. then no more virtual cocpit, alhtough i dont know how htis will effect the actual virtual cocpit, but this plane really didnt have one, that is why i havent cheaked

Ok, well, that actually didnt work, i had movied the veiw point, and that is what fixed the problem, but it caused another. So im back to square one. dose anybody know what to do?

Didn't think it would sorry

Right, if you have a clash with the VC (and it happens with a lot of planes - some designers seem to think that including a poor VC is better than not having one - it isn't because it messes the views up if you add a good replacement panel with views) all you do is get hold of a trusty hex editor and remove the VC from the model. It's easy if you are computer savvy enough to have a go.

Are you Grasshopper?  Are you

Let us know. If not, if you email the model file (or tell us which aircraft it is so we can get hold of it) I or someone else will do it for you in about 2 minutes flat and send you the file back.

yea, are there any hex editors you would recomend? And what is that grasshopper thing?