737-800 Panel With Trinkets

[BobF]

I downloaded and installed the 737-800 Panel with Trinkets by Skilaeb Dygsbi here today. There is no e-mail for Skilaeb. I get an error when trying to use the HUD. It says configuration error - Check your ini file. The entry in the panel.cfg is:

HUDCA$/config!config, 0,0,,, ./gauges/HUDCA$/B737config.ini

I don't know what this is as there is no HUDCA$/config gauge or any ini entry. Thanks, Bob.

[Webb]

For now you can REM out that line by putting // in front of it.

[BobF]

Hi. Thanks. If I rem it out will the HUD work OK? Regards, Bob.

[Webb]

Everything should work the same as it does now but without the error message.  That line of code isn't doing anything anyway.

I didn't install the panel.  I just downloaded it and examined the code.  It's a pretty obvious mistake.

[BobF]

HI. OK. Thanks. I'll try it. Regards, Bob.

[BobF]

[quote]Everything should work the same as it does now but without the error message.