Print view
Board index ‹ Design Forums ‹ Scenery & Panel Design

Exclude problem

FSSC, Airport 2.*, CfgEdit, etc. Get to grips with designing Scenery & Panels here!
Post a reply

Exclude problem

Postby jive1 » Thu May 21, 2009 9:40 am

Hey!

Something that I can't understand...

With ExcludeBuilder.V2, I want to make an excl-file for UACP

It gives me:

jive1
Ground hog
Ground hog
 
Posts: 48
Joined: Sat Jan 11, 2003 4:13 am
Location: Blaasveld, Belgium
Top

Re: Exclude problem

Postby dave3cu » Thu May 21, 2009 10:34 am

Though Bglcomp is throwing an error indicating the Lat-min. and Lat-max. are out of order, I think the problem may be the commas (,) instead of decimal (.) in the xml coordinate values. When I convert the , to . the compile is successful.
Last edited by dave3cu on Thu May 21, 2009 10:53 am, edited 1 time in total.
At that time [1909] the chief engineer was almost always the chief test pilot as well. That had the fortunate result of eliminating poor engineering early in aviation.
dave3cu
Major
Major
 
Posts: 3141
Joined: Sun May 19, 2002 9:55 am
Location: 3CU, Northern Wisconsin, USA
Top

Re: Exclude problem

Postby jive1 » Thu May 21, 2009 11:02 am

Hey! Dave,
Thank you for the help!
Telling me that something is wrong with lat/long order, you made me thinking and watching, and indeed...
I'm living in Belgium in the Dutch speaking part, and we use a so called belgian keybord and have belgian characterset. And here de lat/long values usually are written with a COMMA and not with a DOT.
As soon as I changed the commas into dots, the compiler did the job like it should.
The error was found.
Thank you for the help.
Greetz
Jive1
jive1
Ground hog
Ground hog
 
Posts: 48
Joined: Sat Jan 11, 2003 4:13 am
Location: Blaasveld, Belgium
Top
Post a reply

Return to Scenery & Panel Design

Who is online

Users browsing this forum: No registered users and 275 guests