Print view
Board index ‹ Design Forums ‹ Scenery & Panel Design

AFCAD

FSSC, Airport 2.*, CfgEdit, etc. Get to grips with designing Scenery & Panels here!
Post a reply

AFCAD

Postby colsie123 » Fri Aug 17, 2007 6:24 pm

Can someone tell me how you make a brnad new non exicstent airport in AFCAD and also the lattitude and longtitude for it and a link to the latest version please my version is 44 months old.
Join my VA go on
User avatar
colsie123
2nd Lieutenant
2nd Lieutenant
 
Posts: 168
Joined: Mon Aug 13, 2007 1:15 pm
Location: Glasgow
Top

Re: AFCAD

Postby dave3cu » Fri Aug 17, 2007 7:05 pm

Don't worry about the 'your version is XX months old.....', it just pops up now and then. The version (2.21) in the SimV downloads is the latest.

To start a new airport: Read the User Manual, 'Readme.htm', that is included.

Section 52. Creating a New Airport From Scratch

Dave
At that time [1909] the chief engineer was almost always the chief test pilot as well. That had the fortunate result of eliminating poor engineering early in aviation.
dave3cu
Major
Major
 
Posts: 3141
Joined: Sun May 19, 2002 9:55 am
Location: 3CU, Northern Wisconsin, USA
Top

Re: AFCAD

Postby colsie123 » Sat Aug 18, 2007 4:42 am

Hey thanks a lot ill give that manual a good looking at sometime.  ;D
Join my VA go on
User avatar
colsie123
2nd Lieutenant
2nd Lieutenant
 
Posts: 168
Joined: Mon Aug 13, 2007 1:15 pm
Location: Glasgow
Top
Post a reply

Return to Scenery & Panel Design

Who is online

Users browsing this forum: No registered users and 205 guests