Print view
Board index ‹ Design Forums ‹ Scenery & Panel Design

Help with a few problems please...

FSSC, Airport 2.*, CfgEdit, etc. Get to grips with designing Scenery & Panels here!
Post a reply

Help with a few problems please...

Postby F3Hadlow » Tue Jan 10, 2006 8:29 am

I hope this is in the right forum.
With my AI traffic I have a problem at airfields I have installed new scenery for. First problem is that when my aircraft taxi out and land/takeoff they hover about 20 feet above ground level.
Second problem is that when my AI is parked they clash with static aircraft that come with the scenery.
Can anyone help me with these problems?
Thanks for any help :)
Last edited by F3Hadlow on Tue Jan 10, 2006 8:37 am, edited 1 time in total.
F3Hadlow
 
Top

Re: Help with a few problems please...

Postby dave3cu » Tue Jan 10, 2006 6:45 pm

Sounds like you need an Afcad file that matches the scenery.

Recheck the scenery download instructions to see if you missed installing an included Afcad file, or a pointer to an Afcad file for the scenery.

Or re-visit the site where you got the scenery, maybe someone has created an Afcad file for that scenery.

If that fails,
Last edited by dave3cu on Tue Jan 10, 2006 6:46 pm, edited 1 time in total.
At that time [1909] the chief engineer was almost always the chief test pilot as well. That had the fortunate result of eliminating poor engineering early in aviation.
dave3cu
Major
Major
 
Posts: 3141
Joined: Sun May 19, 2002 9:55 am
Location: 3CU, Northern Wisconsin, USA
Top
Post a reply

Return to Scenery & Panel Design

Who is online

Users browsing this forum: No registered users and 245 guests