vertical trim sensitivity

[washburn_it]

Hi,

time ago I posted here a similar thread...I got some replies but unfortunately none of them helped...so here I go again  ;D
Where can I set the vertical trim sensitivity related to a panel?
Specifically I downloaded a panel for the ATR42-500 (Air Dolomiti) and the original panel "shipped" with the aircraft was ok but the one I downloaded (if I'm correct the one from Francisco something...sorry) is much more better for the graphics but the trim regulator (adjusted with the joystick) is too sensitive so I have the aircraft that "jump" with the nose up or down just touching the trim regulator making the aircraft stabilization almost impossible or hard to do !
How can I reduce this sensitivity?

Thank you and best regards.

Bob

[Brett_Henderson]

In the aircraft's