Simviation Forums

I finally decided to paint Brett's Bonanza, and the paintkit is works perfect apart for 2 places that don't seem to paint:

1) The area between the two tails
2) The front areas of the nose.

I'd appreciate it if someone could point out where on the paintkit I should paint to color these areas.

Thanks alot, and another thank you to Brett for creating this amazing bird.
Frequent Flyer

Well the nose paint is below the tyre texture, but I can't find a separate texture for that tail thing... :-/

Well the nose paint is below the tyre texture, but I can't find a separate texture for that tail thing... :-/

Thanks, found it on the paintkit.

Anyone knows where I can paint the roof are? [See picture]

Take a look at the original paint..  see where it  has to "stagger" ?  That's the top of the empenage..

[quote]Take a look at the original paint..

One last question:
Where do I paint (actually, un-paint) the following places?

That's the antenna and some parts of the 1st window on the right side.

Thanks!

The door is mapped to align with the right side of the fuselage. It is a planar map, and the fuselage halfs are mapped by selected polygons from a cylindrical UVW. The door mapping "stretches" a bit, and is picking up part of the stripe along the top.. You'll have to narrow that strip a bit.

The antenna is mapped so that it maches the "roof".

Long story short.. you can't stripe the roof..  due to short-comings in my mapping skill (patience   :P )

[quote]The door is mapped to align with the right side of the fuselage. It is a planar map, and the fuselage halfs are mapped by selected polygons from a cylindrical UVW. The door mapping "stretches" a bit, and is picking up part of the stripe along the top.. You'll have to narrow that strip a bit.

The antenna is mapped so that it maches the "roof".

Long story short.. you can't stripe the roof..