Simviation Forums

Hi guys,

Every time I repaint an aircraft, I load up FS, start flying an then I notice the textures are blurry

Now I know about using DXTBmp, I open the texure in that first, load it into PSP 8 and start repainting.

When I've finished the textures look great, reload in DXT after editing and save.

I've just downloaded all the repainting tutes available here, but was wondering if anyone could help too

Cheers,

Carl

I find after a few beers my textures go blurry

I find after a few beers my textures go blurry

HAHA! yeah, that is a big problem in FS, no textures that supports beer.

Anyway, have you checked the resulution on the textures? When you load the textures into Photoshop be sure that the files are in bmp format.

Ah ye olde blurry texture problem (with or without beer  ;) ) i suggest saving files in 32Bit not DXT3 and if blurryness strill persists, zoom in to max, then back out, to remove blurryness for a time (FS9 problem i'm told) If they still blur, then try turing down other settings like scenery and weather.

Also get rid of the Mips

Regards,
Stratobat

Igorski :  :-*

It works , so what's your poison (scotch, lager, whisky.........)

Strat : Thanks man, will keep that in mind for next time , since I tried Igorski's tip, it works fine

Thanks for all the help guys,

Carl..........* happily repainting the Nimrod Mk2 with new numbers *

lol am only just 18 by a few months  ;)... lager...  8)

Its cause of ure FS setting where u chose ure res size, check the slider at the bottom... forgot what it says but put it all the way to the max...

Ohhh and check ure mipmap settings are near the max tooo..

Think this works anyways....
read it somewhere aaaaggggesss agooo...

Aye, they're always at max now