First, major KUDOS are in order to Richard Probst and George Carty for their design of the 727-200Adv panel! This was the last airplane I flew prior to a career change in 1998 and their rendering of the cockpit is truly exceptional!!...to the point that it required a dredging of my memory banks and reading of their documentation to remind myself of the quirkiness of some of the operations
I am wondering if there is a way to ge the rising runway in the ADI to behave normally on takeoff. It stays exposed and flagged (Runway) throughout the flight until on approach.
Second question that may have nothing to do with this panel is that last night on my second trip with my newly-outfitted 727, I experienced an AC electrical failure while climbing out of about 16,000' (hard to tell as the Altimeter flag made it pretty difficult to see the digits) which caused the ADI to roll over and die along with a very pretty array of other assorted flags. With the assistance of the DEN APP controller I managed to get the A/C back on the ground using the HSI, ROC and ALT (would have been much easier in the daytime!:)) but I'm wondering if you have any idea what caused this? Maybe an incomplete start sequence? as I'm pretty lazy and usually just use CTL-E while I'm setting up NAV radios, etc. but last night this only started #1 so as I was getting late, just flipped all three start switches, which worked...
Maybe just a sim glitch but it seemed so specific that it made me consider the possibility that I'd missed something.
I have read all the documentation that came with the panel installation.
Once again I'd like to express my sincere appreciation for this brilliant cockpit!!
Cheers!
Rob Wilkinson
CYYC