Simviation Forums

Trying to create a simple cube by entering the measurements in the gmax Keyboard entry, press Create but nothing happens. I am using Gmax 1.2 version which i have for sometime and never had this problem before. Only recently have installed the gmax sdk pack not sure if that has anything to do with it.

                             Thanks Mantab

Problem Solved had to reistall Gmax and silly mistake by me did not
enter the Preferences Settings correctly, cant aderstand how I could do that its not the first time I had to reinstall Gmax over the years.

In Customize > Units Setup I had Metric = Meters which is what I prefer.

But In Preferences Settings > General Tab > 1Unit = Meters which is correct I had 1Unit = inches which was incorrect.

             Thanks anyway guys.
                                       Regards Mantab.

OR - you could have hit Zoom extents all.....

Actually I did that but at the end of the day I prefered not to have what I call a bandade fix.

Actually I did that but at the end of the day I prefered not to have what I call a bandade fix.

Whaaa? :-?

Zoom Extents is something I use twenty or 150 times per session . . . what makes it a "Band-Aid" fix?

OR - you could have hit Zoom extents all.....

While that would have indeed allowed him to zoom in on the part(s), when exported the model would have been W A Y out of scale!

Best to fix the unit scale error before wasting any time on an out-of-scale project!  ;D

OR - you could have hit Zoom extents all.....

While that would have indeed allowed him to zoom in on the part(s), when exported the model would have been W A Y out of scale!

Best to fix the unit scale error before wasting any time on an out-of-scale project!

OR - you could have hit Zoom extents all.....

While that would have indeed allowed him to zoom in on the part(s), when exported the model would have been W A Y out of scale!

Best to fix the unit scale error before wasting any time on an out-of-scale project!

[quote]

Ahhh!