Page 1 of 1
4-blade prop.
Posted:
Sat Aug 28, 2004 4:27 pmby Gringo6
I've seen a 4-blade prop. conversion somewhere in these vast sources of information but now when I want it - it's not to be found.
Can anybody help ?
Re: 4-blade prop.
Posted:
Sat Aug 28, 2004 9:43 pmby Travis
Could you be a bit more specific about what you need?
What program? FSDS? Gmax?
What do you mean a conversion to 4 blades? You want to make an aircraft with 3 blades that is already working in FS into a 4 bladed prop?
Four blade prop.
Posted:
Sun Aug 29, 2004 2:02 pmby Gringo6
Yes that's right. No big deal about it. It's just that I remembered (or thought I remembered) somewhere
in going thru the material presented on this site that somebody had listed a four bladed prop cpnversion and after looking for it again, and not finding it, I posted this querry hoping that someone would tell me where it was located
Re: 4-blade prop.
Posted:
Sun Aug 29, 2004 3:23 pmby andyjohnston.net
You can go into the cfg and change the setting from 3 blades to 4, but to change the visual model you'd need access to the original source.