Page 1 of 1

 The Nervous Nelly

PostPosted: Mon Jul 07, 2003 6:24 am
by nickname
Hello all

I

Re:  

PostPosted: Mon Jul 07, 2003 6:50 am
by Felix/FFDS
typically, BBS (or "Bouncing Betty Syndrome") is attributable to marginal landing gear damping/spring values.  I've seen it especially when using  flight dynamics from an earlier flightsim version.  Due to differences between flightsim versions you can get such annoying happenings...

Re:  

PostPosted: Mon Jul 07, 2003 7:21 am
by nickname
Thanks Felix,

This is an area I have not looked at, as it is kind off confusing  but I

Re:  

PostPosted: Mon Jul 07, 2003 10:36 am
by nickname
Thanks again Felix, got it sorted

Re:

PostPosted: Mon Jul 07, 2003 11:58 am
by Felix/FFDS
"got it sorted" is not an acceptable answer.

What did you do to get it sorted - damping values?  contact points?



Thanks again Felix, got it sorted

Re:  

PostPosted: Mon Jul 07, 2003 5:56 pm
by nickname
Sorry Felix, 1:00am things were getting fuzzy. It was the damping values. I just softened up the rear landing gear as that was where the bounce was coming from.
Thanks for the pointer it saved a lot of frustration.

Regards,

Nickname.