Simviation Forums

how do you keep the pilot from being seen in vc mode(CFS2), when building with Gmax?THANX

Do not include the pilot figure in the vc "interior" group of parts.?

how do you keep the pilot from being seen in vc mode(CFS2), when building with Gmax?THANX

OK Felix Im a DUMMY,I must be missing something on my conversion.If its not too much trouble ,can you explain it  ???

If I understand the VC modelling process correctly, you must make a copy of the parts that you want visible from the VC and group them into an "interior" group. and saved as a separate " scene"

The parts that you want visible go into an "exterior" group. and saved as a separate "scene"

Each group is imported into a new "scene" and exported to the sim.

Isn't that the way it's done?  I would presume that your pilot figure is also included in the "interior"  group, and as such, visible in the vc.




[quote]OK Felix Im a DUMMY,I must be missing something on my conversion.If its not too much trouble ,can you explain it

I dont know for sure how its done.I just make one scene and export with MiddleMan ect... I will try this.THANX ALOT FELIX.

OK that worked Felix THANX, but in the 1st one some txtrs on the windscreen frame didnt make it, so I did it again, and they were ok but a different set ot txtrs didnt make it?? I tried again and back to the 1st txtr not making it.Any suggs on it I am grouping interiors and exteriors from a source I know are complete.The more I learn about Gmax, the more I realize it has to be done perfect or it dont work right!!