Overclocking halp

[Slotback]

Hey guys

*Original questions removed*

Would a P35-DS3P run at 333mhz FSB still at 266 strap? Or need more MCH voltage?

Thanks.

[NickN]

a P35 assuming the BIOS is wel made will have 400Hz ability with straps up through 400

how stable it runs depends on the processor, memory and user

[Slotback]

Nice, got to 3ghz now with not a single problem. 58 load, 36 idle with power saving options enabled - not bad for 1.325 VID on stock cooling. Cooler than stock infact.

[NickN]

you will never run tRD4 unless you are a liquid nitrogen overclocker and dont mind replacing memory sticks from overvoltage burnout

tRD6 yes, 5 possibly but I doubt it... 4 is quite out of reach

[Slotback]

Ran tRD 5 with no problems on stock voltage.

What's better...

266 strap, 4:5 DDR2-890 4-4-4-15, 356 x 9 = 3.2ghz

OR

266 strap, 1:2, DDR2-800 4-4-4-12, 400 x 8 = 3.2ghz

?

Thanks.

EDIT:

At 356 FSB, OCCT fails the test after a few minutes, it is not the memory or CPU.... do I need to add more FSB voltage, or more, FSB voltage?

tRD is in bios as 'static t read'. Should be that in Gigabyte mobos, even older ones.... I thought first board to have that option was the X48...?

[NickN]

266 strap, 1:2, DDR2-800 4-4-4-12, 400 x 8 = 3.2ghz


if its stable leave it there


apparently your memory is holding you back